Support Center » Knowledgebase » My material is shooting out of the front of my Q Series. What do I do?
 My material is shooting out of the front of my Q Series. What do I do?
Solution If the Q-Series rolls material out of the front of the machine you need to press the NEXT key when it says Roll1 FRONT set or Roll2 FRONT set.  This will change it to REAR set indicating that you are loading the material from the back of the machine.
 
As far as the tracking make sure you are looking at the RIGHT EDGE of the vinyl & lining it up with the white squares.
 
We recommend you pull a couple feet of material through the machine & use the RIGHT EDGE of the vinyl & the little white boxes to line it up.
You shouldn't try to align material by looking at the front edge of it.  Then lock down the pinch rollers & choose Roll 1 Rear Set.

As it backs up the material watch the right edge to make sure it stays lined up where you put it.
Also make sure the cutter is on a level surface.
 



Article Details
Article ID: 628
Created On: 27 Aug 2009 02:52 PM

 This answer was helpful  This answer was not helpful

  User Comments Add a Comment
 Back
Theme by SupportSkins.com
Home  -  Knowledgebase  -  Troubleshooter  -  News  -  Downloads
SignWarehouse.com® 800-699-5514 2614 Texoma Drive. Denison, Texas, 75020 Copyright © 2007, Grayson Business Computers, Inc. All rights reserved. All products, services, and company names listed in this web site are trademarks or registered trademarks of their respective holders.