Chemica HotMark Glossy Heat Transfer Vinyl - 14.75 in x 66 ft - White
Shipping Weight: 7.00 lbs.
Product Details: Chemica HotMark Glossy Heat Transfer Vinyl - 14.75 in x 66 ft - White
- Shiny polyurethane film
- Backside Ironing
- Cotton, polyester, acrylic and similar fibers
- 5.5 mil
- Actual material size: 14.75 inch width
- Cut with a 45 degree blade
- Peel cold
Heat pressing: 360 degrees F for 15-20 seconds.
Application Directions: Reverse cut with a 45 degree blade. Weed excess material. Heat press the image on the garment with its polyester carrier protected by a silicone paper at 360 degrees F - 5 seconds. Heat press again at 260 F degrees - 20 seconds - medium pressure. Peel cold.
Wash Instructions: Don't exceed water temperatures of 180 degrees F. Wash inside out.
Note: Due to variety if textiles and their treatments, conduct a print trial before each use. For best results always apply layers of like products. Example: Glossy onto Glossy.
- Customer Reviews
Average Customer Review: 4.5 out of 5 (4 Reviews)
Click here to write an review and share your thoughts with others.
If it is hard to peel, then do this...
If it is hard to peel just make sure to put the setting on a higher cutting force on the plotter. I use same setting for all my shirts.... 395 degrees, hard press down force, and leave on for 20 - 24 sec. Let it cool and peel backing. Then I reapply to press with Teflon tape on top and press again for 6 sec. Works great for me.
Myra Counts (Elora, TN) 10/6/2014
HOTMARK 70 is #1
This is my number one choice in Heat transfer vinyl. I put my press on 335 for 20 sec with high pressure the first time, then I pull plastic backing cover off. Then apply teflon sheet and press again for 10 seconds at a high pressure. I still have shirts that I pressed 4 years ago that still look as good. Vinyl looks better than the shirt after years...Highly recommend
zayzcustomdecalandsigns (CUMBERLAND, KY) 9/24/2013
Hard to Find Right Settings?
I am having trouble pressing. Using 300F @ 20 seconds w/ teflon sheet. Top half seems like it doesnt want to stick, repressed looks a bit wrinklish. Am i doing something wrong with this or what?
EDITOR: Hello Fidel! Try increasing the pressure on your heat press. HotMark requires more pressure for the adhesive to set. Please click here for more information about this.
FIDEL MARTINEZ (SAN PABLO, CA) 10/22/2011
Hot Mark 70 is the BEST I've found
It is TRUELY easy weed and it withstands the abuse of my clothes drier. I find that the white adheres the best and if I press it again with a teflon sheet (after allowing it to cool & then removing the plastic) it doesn't lift or curl, even after multiple washes.
J Gravel (Escondido, CA) 8/30/2009